Heat the hosel before step drilling a broken shaft!   more »

Every surface that the epoxy is asked to bond with has to be clean, abraided, and able to accept enough material to make a bond - but not so much as to "sag out" or exit the bonding area.   more »

The painted surfaces of metal woods are easy to refinish with just some basic tools and a little patience. In this workshop segment, let's take a closer look at step by step metal wood refinishing...   more »

Removing graphite shafts is a very common procedure in most clubmaking operations. The key is to successfully remove the shaft so that it may be used again. Doing that with a regular amount of success is something that takes the right equipment and a lot of patience...    more »